641 How To: Drain a Toilet

How To: Drain a Toilet


 |  ❤ 25  |  ☻ 0
Category: Bathroom
  1. 5
  2. 4
  3. 3
  4. 2
  5. 1
(0 votes, average: 0 out of 5)

How To: Drain a Toilet

Before repairing or replacing a toilet, use this tutorial to master an essential prep task.

Whether fixing a toilet that’s running or leaking from the base, cleaning the tank, or replacing a unit that’s beyond repair, your first step must be to drain the toilet in order to inspect its internal parts and avoid a flood on the bathroom floor. Fortunately, eliminating water from both the tank and the bowl is among the easiest, least messy toilet-related DIY tasks, using supplies you no doubt already have on hand. If you find yourself querying Google for how to clean a toilet, look no further: We’ve outlined the simple step-by-step instructions and the tools that make it easy.

How To: Drain a Toilet

TOOLS AND MATERIALS

– Towels
– Rubber gloves
– Fivegallon bucket with a handle
– Shampoo rinsing pitcher
– Bathroom tumbler
– Large cleaning sponge

STEP 1

Protect your bathroom floor by laying old towels around the base of the toilet. Fully lift the toilet seat cover and toilet seat toward the front of the toilet tank to protect them from potential splash back.

STEP 2

Locate the metal shut-off valve along the wall behind the toilet, usually near the base of the tank. Manually twist the valve clockwise until tight to turn off the water supply to the toilet.

STEP 3

Use gloved hands to lift the lid of the toilet tank and gently set it on a flat, soft surface, such as a rug on the floor. (The lids of standard porcelain toilets can crack if abruptly placed on a hard surface.)

READ  Quick Tip: Laying Bathroom Tile

STEP 4

Flush the toilet, keeping the flush lever depressed until the water level inside the tank empties as much as possible. At this point, the tank will either be completely empty or filled with less than half an inch of water. If the tank is empty, go to Step 6. If the tank still contains some water, proceed to the next step.

STEP 5

Soak up any water remaining in the tank with a large and absorbent cleaning sponge. Squeeze the sponge over the toilet bowl to discard the water, and then set the sponge aside.

STEP 6

Fill a five-gallon bucket with three gallons of plain cold water. The easiest way to fill the bucket is to place it in the bathtub and run the cold tap. If you have a half bath without a tub, fill a shampoo rinsing pitcher or a tumbler (no more than eight inches tall) with water from the bathroom sink, then empty its contents in the bucket, repeating this process until the bucket has roughly three gallons of water.

STEP 7

Tote the bucket to the toilet. Lifting the bucket to the height of a few inches above the toilet bowl, quickly start to pour the water into the toilet bowl, gradually lifting the bucket to a height of one foot above the toilet bowl until the bucket is empty.

While pouring water into the bowl sounds counterintuitive for draining a toilet, lifting up the bucket as you pour will speed up the water flow and encourage most of the remaining water in the bowl to go down the drain—similar to a flush.

READ  How To: Unclog a Bathtub

STEP 8

To drain the toilet completely dry, soak up any standing water that remains in the toilet bowl with the large sponge. Now, you’re ready to proceed with your toilet repair or maintenance task. When your toilet is back in business, remove any towels from the bathroom floor, and turn the toilet shut-off valve counterclockwise to restore the water supply to your commode.

Leave a Reply

Your email address will not be published. Required fields are marked *

seventeen − 5 =

top